Effect of breathing patterns on mandibular cortical bone quality in children and establishment of a preliminary screening model.

OBJECTIVE: This retrospective study analyzed breathing patterns and age subgroups effect on cortical bone quality of the mandible in growing subjects, aiming to explore the application value of facial skeletal pattern combined with cortical bone density detection in early screening diagnosis of mouth breathing. METHODS: One hundred twenty-six participants were divided into four groups: mouth breathing group (7-9, 10-12 years old) and nasal breathing group (7-9, 10-12 years old). The mandibular anterior, middle, and posterior cortical bone mineral density (CBMD), cortical bone width (MCW), ANB, and FMA values were measured. Independent T-test and Mann-Whitney U test were used to compare the measured values. Binary logistic regression was employed to analyze the correlation between measured variables and the children's breathing patterns. ROC analysis was used to determine the ability of the cortical bone density measurements in early screening diagnosis of MB. RESULTS: Mouth breathing had a negative impact on CBMD and MCW of the pre-mandibular (Pog) in subjects aged 7-9 years and also impacted the development of (Pog) and submandibular (Me) sites in subjects aged 10-12 years. Older children in the nasal breathing group have higher CBMD, MCW, and SNB values and lower FMA values. Single-factor and multiple-factor logistic binary regression analysis showed that FMA, MSPogCBMD, MSPogMCW, and ANB are correlated factors for children at risk of mouth breathing. CONCLUSION: Mouth breathing pattern is closely associated with decreased mandibular CBMD and MCW values in children aged 7-12, where the anterior (Pog) and inferior (Me) sites of anterior mandible are more significantly affected. Furthermore, in combination with facial skeletal pattern, it provides a basis for the early warning diagnosis of mouth breathing.

Evaluation of the stability of the palatal rugae using the three-dimensional superimposition technique following orthodontic treatment.

OBJECTIVES: To determine the uniqueness and stability of the palatal rugae after orthodontic treatment. METHODS: Cast models of untreated subjects (n = 50) were obtained twice at intervals of 8-30 months. Cast models of patients who received non-extraction (n = 50) and extraction (n = 50) orthodontic treatment were obtained before and after treatment at intervals of 11-41 months and 14-49 months, respectively. All 300 cast models were scanned digitally. The palatal rugae were manually extracted and transformed into 3D point clouds using reverse engineering software. An iterative closest point (ICP) registration algorithm based on correntropy was applied, and the minimum point-to-point root mean square (RMS) distances were calculated to analyze the deviation of palatal rugae for scans of the same subject (intrasubject deviation [ISD]) and between different subjects (between-subject deviation [BSD]). Differences in ISD between each group and the deviation between ISD and BSD of all 150 subjects were evaluated. RESULTS: Significant differences were found in the 150 ISD and 1225 BSD in each group, as well as the 150 ISD and 11,175 BSD across all groups. The mean values of ISD in untreated, non-extraction and extraction group were 0.178, 0.229 and 0.333 mm, respectively. When the first ruga was excluded in the extraction group, the mean ISD decreased to 0.241 mm, which was not significantly different from that in the non-extraction group (p = 0.314). CONCLUSIONS: Orthodontic treatment can influence the palatal rugae, especially in cases of extraction. Furthermore, variation mainly existed in the first ruga in cases of extraction. However, palatal rugae are still unique and may be used as a supplementary tool for individual identification. CLINICAL SIGNIFICANCE: This study indicates that palatal rugae might be applied in the evaluation of orthodontic tooth movement and forensic individual identification. The registration algorithm based on correntropy provides a reliable, precise, and convenient method for palatal rugae superimposition.

Efficiency evaluation of maxillary molar distalization using Invisalign based on palatal rugae registration.

INTRODUCTION: This study aimed to compare the predicted maxillary molar distalization with the achieved clinical outcome using the palatal rugae area for registration and superimposition of digital models. Understanding Invisalign efficiency may assist clinicians in predicting changes, thus applying specific measures to minimize the chance of midcourse correction later. METHODS: The study sample included 38 patients with a mean age of 25.4 years, eligible for Invisalign treatment and requiring distalization of maxillary molars. Two digital models were acquired using iTero intraoral scanner (Align Technology, Santa Clara, Calif) before treatment and after maxillary first and second molar distalization. The 2 digital models were superimposed using the palatal rugae area for registration. The predicted tooth movement compared to the achieved values. One hundred forty-two maxillary molars (71 first molar and 71 second molar) were measured for distal movement, and 228 maxillary anterior teeth were evaluated for anterior anchorage loss. RESULTS: The predicted distal movement of the maxillary first molar (P <0.0001) and maxillary second molar (P <0.0001) differed significantly from the actual values. There was a statistically significant correlation between the amount of distal molar movement and the amount of anchorage loss (r = 0.3900, P <0.008) for the central incisor, and (r = 0.3595, P <0.013) for the lateral incisor. CONCLUSIONS: Invisalign can be used successfully for adult patients requiring maxillary molar distalization when a mean distalization movement of 2.6 mm was prescribed. Clinicians should be aware of the countereffect if maxillary molars are planned to move distally, especially if the patient presented initially with a large overjet, so the need to prescribe overcorrection or the use of auxiliaries can be addressed earlier.